Page History

The wait() method is employed to temporarily cede possession of a lock so that another thread can proceed. It must always be used inside a synchronized block. To resume activity, the other thread must notify the waiting thread. Moreover, the wait method should be invoked in a loop that checks if a condition predicate holds.

A condition statement is used so that the correct thread is notified since as invocation of notify() or notifyAll() in another thread cannot pin point which waiting thread needs to must be resumed. Another use is that sometimes a thread needs is required to block until a condition becomes true, for instance, when it cannot proceed without obtaining some data from a stream.

synchronized (object) {
  while (<condition does not hold>) {
    object.wait(); 
  }

  //proceed when condition holds
}

Two properties come into the picture here:

• Liveness: Every operation or method invocation executes to completion without interruptions, even if it goes against safety.

• Wiki Markup
  Safety: Its main goal is to ensure that all objects maintain consistent states in a multi-threaded environment. \[[Lea 00|AA. Java References#Lea 00]\]

...

To guarantee _safety_, the while loop condition shouldmust be tested even after the call to {{wait}}. While {{wait()}} is meant to block indefinitely till a notification is received, this practice is touted because: \[[Bloch 01|AA. Java References#Bloch 01]\] 

• Thread in the middle: A third thread can acquire the lock on the shared object during the interval between a notification being sent and the receiving thread actually resuming execution. This thread can change the state of the object leaving it inconsistent. This is akin to the "time of call, time of use" (TOCTOU) condition.
• Malicious notifications: There is no guarantee that a notification will not be sent when the condition does not hold. This means that the invocation of wait will be () is nullified by the notification.
• Sometimes on receipt of a notifyAll() signal, an unrelated thread can start executing and it is possible for its condition to be true.
• Certain JVM implementations are vulnerable to spurious wakeups, that result in waiting threads waking up even without a notification.

Due to Because of these reasons, checking it is indispensable to check the condition after wait() is called is indispensable.

Noncompliant Code Example

This noncompliant example invokes the wait() method inside a traditional if block and fails to check the post condition after the notification (accidental or malicious) notification is received. This means that the thread can waken when it is not supposed to.

synchronized(object) {
  if(<condition does not hold>)
    object.wait();
  //proceed when condition holds
}

Compliant Solution

The This compliant solution encloses the wait() method in a while loop and as a result checks the condition during both pre and post wait() invocation times.

//condition predicate is guarded by a lock on the shared object/variable
synchronized (object) {
  while (<condition does not hold>) {
    object.wait(); 
  }

  //proceed when condition holds
}

...

To guarantee liveness and safety, the wait() method should always be called inside a while loop.

...