You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

Perl provides three logical operators: &&, ||, and !, and they have the same meaning as in C.

Perl also provides three alternative logical operators: and, or, and not. They have the same meanings as &&, ||, and !. They have much lower binding precedence, which makes them useful for control flow [Wall 2011]. They are called the late-precedence logical operators, whereas &&, ||, and ! are called the early-precedence logical operators.

It is possible to mix the early-precedence logical operators with the late-precedence logical operators, but this mixture of precedence often leads to confusing, counterintuitive behavior. Therefore, every Perl expression should use either the early-precedence operators or the late-precedence ones, never both.

[Conway 2005] recommends avoiding the use of not and and entirely and using or only in control-flow operations, as a failure mode:

    print $filehandle $data    or croak("Can't write to file: $!");

Noncompliant Code Example

This noncompliant code example checks a file for suitability as an output file. It does this by checking to see that the file does not exist.

if (not -f $file) {

This code is perfectly fine. However, it is later amended to also work if the file does exist but can be overwritten.

if (not -f $file || -w $file) {

This code will not behave as expected because the binding rules are lower for the not operator than for the ! operator. Instead, this code behaves as follows:

if (not (-f $file || -w $file)) {

when the maintainer really wanted:

if ((not -f $file) || -w $file) {

Compliant Solution

This compliant solution uses the ! operator in conjunction with the || operator. This code has the desired behavior of determining if a file either does not exist or does exist but is overwritable.

if (! -f $file || -w $file) {

Compliant Solution

This compliant solution uses the early-precedence operators consistently. Again, the code works as expected.

if (not -f $file or -w $file) {

Risk Assessment

Mixing early-precedence operators with late-precedence operators can produce code with unexpected behavior.

Recommendation

Severity

Likelihood

Remediation Cost

Priority

Level

EXP04-PL

low

unlikely

low

P1

L3

Automated Detection

Tool

Diagnostic

Perl::Critic

ValuesAndExpressions::ProhibitMixedBooleanOperators

Bibliography

[CPAN] Elliot Shank, Perl-Critic-1.116 ProhibitMixedBooleanOperators
[Conway 2005] pg. 70
[Wall 2011] perlop


      02. Expressions      

  • No labels